挖掘机配件链条的准确陈设

日期:2018-08-10   源头:http://www.sefibox.com/
1、挖掘机配件链轮装在轴上应没有倾斜和摆动,在同一传动组件中两个链轮的端面应位于同一平面内,链轮中心距在0、5米以下时,允许缺陷1毫米;链轮中心距在0、5米以上的时,允许缺陷2毫米。但不允许有摩擦链轮齿正面征象,要是两轮偏移过大容易孕育发生脱链和加快磨损。
1. The sprocket of excavator fittings should be installed on the shaft without skew and swing. The end faces of the two sprockets in the same transmission assembly should be in the same plane. When the sprocket center distance is less than 0 or 5 meters, the tolerance is 1 mm; when the sprocket center distance is more than 0 or 5 meters, the tolerance is 2 mm. But it is not allowed to have frictional sprocket tooth side phenomenon, if the two wheels deviate too much, it is easy to produce chain off and accelerated wear.
2、挖掘机配件链条的松紧度应相宜,太紧增长功率斲丧,轴承易磨损;太松链条易跳动和脱链。链条的松紧水平为:从链条的中部提起或压下,两链轮中心距约为2-3cm。
加长臂挖掘机出租
2. The elasticity of the chain of the excavator accessories should be suitable, too tight increases power consumption, bearings are easy to wear; too loose chain is easy to jump and unlock. The elasticity of the chain is as follows: lifting or pressing from the middle of the chain, the center distance of the two sprockets is about 2-3 cm.
3、挖掘机配件新链条过长或经运用后伸长,难以调停,可看环境拆去链节,但必需为偶数。链节应从链条反面穿过,锁片插在外表,锁紧片的启齿应朝转动的相反方向。
3. The new chain of excavator accessories is too long or elongated after use, so it is difficult to adjust. It can be removed according to the situation, but it must be even. The link shall pass through the back of the chain, and the lock plate shall be inserted outside. The opening of the lock plate shall be in the opposite direction of rotation.
4、挖掘机配件链轮磨损告急后,应同时互换新链轮和新链条,以包管精良的啮合。不克不及只独自互换新链条或新链轮,不然会构成啮合不好加快新链条或新链轮的磨损,链轮齿面磨损到水平后应及时翻面运用。
4. After serious wear and tear of sprocket of excavator accessories, new sprocket and new chain should be replaced at the same time to ensure good meshing. The new chain or sprocket can not be replaced separately, otherwise it will cause the wear and tear of the new chain or sprocket, and the sprocket tooth surface should be turned over in time.
5、挖掘机配件旧链条上不克不及与局部新链条殽杂运用,不然容易在传动中孕育发生打击,拉断链条。
5. The old chains of excavator accessories can not be mixed with some new chains, otherwise it is easy to produce impact in the transmission and break the chain.
6、挖掘机配件链条在变乱中应及时加注润滑油,润滑油必需进入滚子和内套的共同间隙,以改良变乱条件,淘汰磨损。
6. The chain of excavator accessories should be filled with lubricating oil in time. The lubricating oil must enter the clearance between roller and inner sleeve to improve working conditions and reduce wear.
7、河北挖掘机配件暂时寄存时,链条应拆下用火油或柴油洗濯洁净,然后涂上机油或黄油寄存在单调处,以防锈蚀。
7. When the parts of Hebei excavator are stored for a long time, the chain should be removed and cleaned with kerosene or diesel oil, then coated with oil or butter and stored in a dry place to prevent rust.
本文由加长臂挖掘机出租提供技术支持,更多的过细小气内容请点击江苏快三开奖结果的官方网站http://www.sefibox.com江苏快三开奖结果将会经心全意为您提供自得的办事。
This article is supported by the Lengthened Arm Excavator rental technology. For more details, please click our official website http://www.sefibox.com and we will provide you with satisfactory service wholeheartedly.

【本站图片均由网站全部方提供,局部图片源头于网络,如偶然偶然中陵犯了某媒体或集团私家的知识产权,请来信或来电告之,本网站将立刻删除。】