出租挖掘机也要连合呆板的实际举行

日期:2018-05-18   源头:http://www.sefibox.com/
  在现有挖机的底子上改装蒸发器(空变卦摇)、水箱散热器及液压散热器,并在水箱散热器和液压散热器之间留出五公分的空间,装上蒸发器,然后再把它们的两边封好,使外界气氛不克不及进入。

  On the basis of the existing excavators, the evaporator (air conditioner), radiator and hydraulic radiator are reformed, and five centimeters of space is left between the radiator and the hydraulic radiator, and the evaporator is installed, and then both sides are sealed so that the outside air can not be entered.

江苏快三开奖结果  运用这种要领(热力紧缩阀)可制冷至零下5~10度。倡议机的电扇把寒气氛吸入,液压散热器和水箱散热器举行热互换后降温,后吹向倡议机及大泵上冷却。

江苏快三开奖结果  In this way, the thermal expansion valve can be refrigerated to zero 5~10 degrees. The fans of the engine suck the cold air, heat the hydraulic radiator and radiator, then cool down, and finally blow to the engine and the big pump to cool down.

  要是倡议机及液压的温度低于50摄氏度,那么紧缩机就会停机;高于75摄氏度,那么制冷紧缩机便会自动变乱。这时只需确保倡议机及液压体系的温度在50~60摄氏度以内,挖机才气正常运转,并抵达佳运转结果。
长臂挖掘机出租

江苏快三开奖结果  If the engine and hydraulic temperature is below 50 degrees Celsius, the compressor will stop; if the temperature is above 75 degrees Celsius, then the refrigeration compressor will work automatically. At this time, only to ensure that the engine and hydraulic system temperature within 50~60 degrees Celsius, the excavator can run normally, and achieve the best operation results.

  桩体挠曲矫正。腹向弯曲矫正是将拉森钢板桩变曲段的两端壮实的支承点上,用设置在龙门式顶梁架上的千斤顶顶在钢板桩迂回处举行冷弯矫正

  The deflection correction of the pile body. The abdominal bending correction is the support point fixed on the two ends of the Larsen steel sheet pile, and the jack top on the Longmen type top beam is corrected by cold bending at the concave and convex section of the steel sheet pile.

  侧向弯曲矫正通常在专门的矫正平台上举行,将拉森钢板桩弯曲段的两端壮着实矫正平台的支座上,用设置在拉森钢板桩的弯曲段正面矫正平台上的千斤顶顶压拉森钢板桩弯凸处,举行冷弯矫正。

江苏快三开奖结果  The lateral bending correction is usually carried out on the special correction platform. The ends of the bending section of the Larsen steel sheet pile are fixed on the support of the correction platform. The bending section of the jack top pressure Larsen steel sheet pile on the platform is corrected with the side of the bending section of the Larsen steel sheet pile to be corrected by cold bending.

  外貌缺陷矫正。先洗濯缺陷相近外貌的锈蚀和油污,然后用焊接修补的要领补平,再用砂轮磨平。

  Correction of surface defects. First, clean the rust and oil stains near the surface of the defects, then repair them by welding and then grind them.

  本文的小气内容来自加长臂挖掘机出租过细内容请点击江苏快三开奖结果的官方网站:http://www.sefibox.com/谢谢您的到来!

江苏快三开奖结果  The highlights of this article are from the detailed description of the long arm excavator rental. Please click on our official website: http://www.sefibox.com/, thank you for coming.

【本站图片均由网站全部方提供,局部图片源头于网络,如偶然偶然中陵犯了某媒体或集团私家的知识产权,请来信或来电告之,本网站将立刻删除。】